How to enhance and protect slate floors
Crommelin Slate Sealer and Water Based Slate Sealer are surface coating sealers to protect and lift natural colours on old and new slate surfaces.
-
YOU WILL NEED
1 litre of each product will coat approximately 6-7m(2) of slate
-
EQUIPMENT
Both Slate Sealers are easily applied by brush or roller
-
NUMBER OF COATS
2 coats are required to give a hardwearing finish to your slate
-
DRYING TIME
Allow 30 minutes between coats
Leave for 4 hours to cure before walking on the floor -
CLEAN UP
Please refer to the specific product label for the most effective method of clean up
-
TIPS
Apply to a dry surface. To test for moisture, tape down a clear plastic sheet over a small section of the surface to be treated in direct sunlight and leave for 2 hours. If moisture appears on the underside of the sheet the area is too damp