How to seal and protect paving with wet look sealers
Crommelin Concrete Paving Sealer and Wet Look Paving Sealer provides durable and long lasting protection to a wide variety of paving and stencilled/patterned concrete surfaces.
-
YOU WILL NEED
1 litre of each of these products will cover approximately 3-5m(2) depending on the porosity of the paved area
-
EQUIPMENT
These products are easily applied by brush, roller or spray
-
NUMBER OF COATS
2 coats are required to give a good stain and water repellant seal to paved surfaces
-
DRYING TIME
Allow 30 minutes drying time between coats
Allow 2 hours before walking on the surface -
CLEAN UP
Please refer to the specific product label for the most effective method of clean up
-
TIPS
Apply to a dry surface. To test for moisture, tape down a clear plastic sheet over a small section of the surface to be treated in direct sunlight and leave for 2 hours. If moisture appears on the underside of the sheet the area is too damp