Pool Paving Sealer

Pool Paving Sealer

Pool Paving Sealer is a clear water repellent treatment that penetrates deep into the surfaces to cure and impede the passage of moisture. It leaves no surface finish, so avoiding increased slipperiness when wet.  Pool Paving Sealer reacts with soluble salts in cementitious surfaces to block capillaries whilst still allowing the substrate to release retained moisture.

View more from: Sealers

  • Features & Benefits
  • Areas of Use

Features & Benefits

  • Penetrating treatment
  • Allows area treated to “breathe”
  • “Invisible” protection
  • Does not increase slipperiness of surface
  • Enhances life of pavers and serviceability
  • Suppresses efflorescence (white salts)
  • Reduces spalling by minimising water penetration

Areas of Use

  • Clay brick
  • Concrete pavers
  • Stencilled concrete
  • Concrete and concrete block
  • In-situ concrete and reconstituted stone paving
  • Natural stone
  • Exposed aggregate panels
  • Reconstituted limestone

How to seal and protect paving around swimming pools and spa's

Instructions

  • YOU WILL NEED

    YOU WILL NEED

    1litre of Pool Paving Sealer will cover approximately 3-5m² depending on the porosity of the paved area

  • EQUIPMENT

    EQUIPMENT

    Pool Paving Sealer is easily applied with a paint brush, roller or spray

  • NUMBER OF COATS

    NUMBER OF COATS

    2 coats are required to give a good stain and water repellent seal to paved areas

  • DRYING TIME

    DRYING TIME

    Allow 30 minutes drying time between coats. Allow 2 hours before walking on surface

  • CLEAN UP

    CLEAN UP

    Pool Paving Sealer is easily cleaned up with mineral turpentine before drying

  • TIPS

    TIPS

    Apply to dry surface. To test moisture, tape down a clear plastic sheet over a small section of the surface to be treated in direct sunlight and leave for 2 hours. If moisture appears on the underside of the sheet the area is too damp

Site by Digital Outlook