Wet Look Paving Sealer is a tough low sheen finish surface treatment that provides a classic “wet look” finish by restoring & enhancing natural colors. The product has been modified to promote extremely low dirt pick up, making treated areas easier to maintain and keep clean. Worn or damaged areas can be recoated without stripping or grinding.
View more from: Sealers
1litre of Wet Look Paving Sealer will cover approximately 3-5m² depending on the porosity of the paved area
Wet Look Paving Sealer is easily applied with a paint brush, roller or spray
2 coats are required to give a good water repellent seal to paved areas
Allow 2 hours drying time between coats
Wet Look Paving Sealer is easily cleaned up with lacquer thinners or Crommelin Cleaning and Thinning Solvent before drying
Apply to dry surface. To test moisture, tape down a clear plastic sheet over a small section of the surface to be treated in direct sunlight and leave for 2 hours. If moisture appears on the underside of the sheet the area is too damp
Other products you may need to finish the project
Cleaning & Thinning Solvent is an aromatic hydrocarbon used as a general purpose solvent....